Metal conical washer under rear suspension bearing original type for BMW Z4 E85 Roadster and E86 Coupe (04/2002-08/2008)

Details about : Metal conical washer under rear suspension bearing original type for BMW Z4 E85 Roadster and E86 Coupe (04/2002-08/2008)

Tapered washer in metal under bearing of rear suspension adapted for shock absorber rod diameter 10 mm original type for BMW Z4 E85 and E86 :

E85 Roadster :
- 2.0i 4 cyl 150hp phase 1 from 06/2004 to 12/2005 (engine code N46B20)
- 2.0i 4 cyl 150hp phase 2 from 01/2006 to 08/2008 (engine code N46B20)
- 2.2i 170hp phase 1 from 12/2002 to 11/2005 (engine code M54B22)
- 2.5i 192hp phase 1 from 04/2002 to 11/2005 (engine code M54B25)
- 2.5i 177hp phase 2 from 10/2004 to 07/2008 (engine code N52B25)
- 2.5si 218hp phase 2 from 10/2004 to 08/2008 (engine code N52B25)
- 3.0i 231hp phase 1 from 04/2002 to 11/2005 (engine code M54B30)
- 3.0si 265hp phase 2 from 10/2004 to 07/2008 (engine code N52B30)
- M 3.2l 343hp phase 2 from 11/2004 to 07/2008 (engine code S54B32)

E86 Coupe:
- 3.0si 265hp from 10/2005 to 08/2008 (engine code N52B30)
- M 3.2l 343hp from 10/2005 to 07/2008 (engine code S54B32)

When installing yourshock absorbersand/or replacing your rear suspension bearings, it is imperative to replace and re-install the seat washers that are located under the bearings (see photo). Otherwise the silentblocks will come out of their housings and the shocks will go "through" the body, which can severely damage your vehicle.

Quantity needed: 2 per vehicle

This product is sold by the unit.