Driveshaft end castle nut for 2cvs before 1970

This driveshaft end castle nut for 2cvs before 1970 is faithful to the original.

This old-fashioned pin locknut is made of dichromate steel.
It is attached to the end of the gearbox shaft and enables you to tighten the hub flange on the s...

Qty :

In stock

Delivery mode

Collect at store Wambrechies (France) : Free

Home delivery : 39.00€

Sent today by MECATECHNIC if ordered before 15h00

Description Product

Customer review

Your questions

Vehicle compatibility

Description Product

Details about : Driveshaft end castle nut for 2cvs before 1970

This driveshaft end castle nut for 2cvs before 1970 is faithful to the original.

This old-fashioned pin locknut is made of dichromate steel.
It is attached to the end of the gearbox shaft and enables you to tighten the hub flange on the steering pivot.

Technical caracteristics

Matériau

Dichromate steel

Quantity required

Width (mm)

Customer review

No commentary about the product

Met Trusted Shops kunnen we direct verbeteren dankzij uw opmerkingen op de MECATECHNIC website

Your questions

Vehicle compatibility

Citroën

Citroën 2CV type A-AZAM :

Visit the category Transmission shaft Citroën 2CV type A-AZAM

Other products in the Drive shaft range

Gearbox-mounted bolt for fixing cardan shaft for 2cv before 1970 - M7X35mm - Bichromate - CV11832

5,85 €

ATI

In stock

Gearbox-mounted bolt for fixing cardan shaft for 2cv before 1970 - M7X35mm - Bichromate

ref: CV11832