MECATECHNIC rear brake distributor for Audi 100 C2 Sedan and Avant Type 43 petrol or diesel (08/1976-08/1982)

Details about : MECATECHNIC rear brake distributor for Audi 100 C2 Sedan and Avant Type 43 petrol or diesel (08/1976-08/1982)

MECATECHNIC rear brake distributor for Audi 100 C2 Sedan and Avant type 43 with drum brakes only:

- 1.6L 4 cylinders 85hp phase 1 from 08/1976 to 07/1979 (engine code YV)
- 1.6L 4 cylinders 85hp phase 2 from 08/1979 to 08/1982 (YV engine code)
- 1.9L 5 cylinders 85hp phase 2 from 10/1980 to 08/1982 (engine code WH)
- 2.0L 4 cylinders 115hp phase 1 from 08/1976 to 08/1978 (engine code WA)
- 2.1L 5 cylinders 115hp phase 1 from 08/1976 to 08/1978 (engine code WB)
- 2.1L 5 cylinders 136hp phase 1 from 05/1977 to 07/1979 (engine code WC)
- 2.1L 5 cylinders 136hp phase 2 from 08/1979 to 08/1982 (engine code WC)
- 2.0D 5 cylinders 70hp phase 1 from 10/1978 to 07/1979 (CN engine code)
- 2.0D 5 cylinders 70hp phase 2 from 08/1979 to 08/1982 (CN engine code)

ATTENTION: Not suitable for models with disc brakes!

Located in front of the left rear wheel, the brake distributor (also known as a compensator or pressure regulator) reduces braking pressure on the rear wheels when the load is transferred to the front, or when the trunk is heavily loaded. If the rear wheels are relieved during heavy braking, or if there is a heavy load in the trunk, there is a risk of the rear wheels locking up, with a consequent loss of braking efficiency. Its valve reduces rear pressure when it becomes too high (pre-set value) to maintain perfect control and stability of the vehicle.

Indispensable for keeping your car on the road safely, and no longer available on the market over the years, this part is an exclusive , high-quality MECATECHNIC remanufactured in Europe. Each distributor is fully tested and calibrated in the factory, offering the same rigorous quality as the original equipment part, according to strict specifications.