TEROSON SB 3140 white gravel remover - spray can - 500ml

TEROSON SB 3140 white anti-gravelling is a synthetic resin-based anti-gravelling material in aerosol form designed to protect visible vehicle parts such as front and rear skirts and door sills against corrosion, chipping debris(stones, pebbles, grav...

Qty :

In stock

Delivery mode

Collect at store Wambrechies (France) : Free

Home delivery : 42.00€

Sent by MECATECHNIC on: Monday, February 17, 2025

Description Product

Customer review

Your questions

Description Product

Details about : TEROSON SB 3140 white gravel remover - spray can - 500ml

TEROSON SB 3140 white anti-gravelling is a synthetic resin-based anti-gravelling material in aerosol form designed to protect visible vehicle parts such as front and rear skirts and door sills against corrosion, chipping debris(stones, pebbles, gravel), road salt and humidity. It can also be used to treat small, isolated surfaces, or to touch up white coatings applied with a spray gun and compressor.
Setting time approx. 2h. It is recommended to prepare the surface with TEROSON VR 10 (reference UO99110 to be ordered separately).

Advantages :
- Convenient spray can format for easy spray application (no need for compressor or special equipment such as spray gun).
- Preserves any type of underbody coating applied by the manufacturer.
- For painted or primer-coated metal surfaces.
- Highly resistant to abrasion.
- Can be painted 15 minutes after application (for best results, painting should be carried out within 6 hours of product application).

Pre-treatment :
- Surfaces to be treated must be clean, dry and free of grease, rust and dirt.
- Areas not to be coated must be properly covered with masking paper.

Directions for use:
- Shake well before use.
- Hold can vertically while spraying and apply two or three coats in criss-cross strokes at a distance of approx. 20-30cm (allow a short evaporation time between coats).
- If masking tape has been used, remove it before the material begins to dry.
- After use, turn the can upside down and run the valve until nothing but propellant comes out (purge).

Please observe all safety precautions.