Battery accessories

6 Volt 66 Ah / 270 A battery
Vintage-style model without base
Dimensions: L 185 x W 170 x H 172mm
Supplied empty for transport.

This battery must be refilled with a specific acid (not provided) and charged using a suitable device prior to being installed in the vehicle. For safety reasons, Mecatechnic does not ship acid.

6 Volt 100 Ampere battery
For maximum power!
Vintage-style model without base
Dimensions: L 225 x W 174 x H 217mm
Supplied empty for transport.

This battery must be refilled with a specific acid (not provided) and charged using a suitable device prior to being installed in the vehicle. For safety reasons, Mecatechnic does not ship acid.

This 12V to 6V voltage reducer allows you to keep your 6V electrical accessories.
It's tempting to convert your 6V vehicle to 12V, but many accessories aren't compatible.Supporting accessories up to 50W, this voltage reducer offers a resistance of 4 Ohm and simply connects in series to the wiring of the accessory you wish to keep in 6V.
It can be grounded, screwed to the body or wired.
Input voltage 12V > output voltage 6V

This TOOLATELIER battery switch, also known as an anti-theft battery lug, is supplied with a 20 amp flat fuse.

Very practical, it maintains the power supply to alarms, clocks, car radios, etc.

The principle is simple: when the contact knob is unscrewed and removed, starting the engine blows the fuse.
This prevents starting and keeps the vehicle stationary.

Terminal diameter: 16mm

Adapter which allows you to use the cigarette lighter socket to charge / hold the charge of the battery. Useful on vehicles where it is difficult to access the battery.

Only for cigarette lighters which are supplied after the ignition is switched on

Cable length: 50 cm
SAE 2 pin connector in compliance with industrial standards.
10 A Fuse (internal connector)
Maximum nominal cable capacity: 10 A.
Rubber sleeve included

Battery pack 80A.
Resistant to acid and petroleum products.
Delivered with strap for closing and transport and an anti-projection cover.
For a 80A battery.
Interior dim.: L:270xD:190xH:200 mm.
Exterior dim: L: 340x D:225 mm.

Large battery compartment.
Resistant to acid and petroleum products.
Delivered with strap for closing and transport and an anti-projection cover.
For batteries withmaximum size : L:390 x D:195x H:240mm.
Interior dimensions: L:390xD:195xH:240 mm.

Battery safety switch housing with detachable key.
Allows the ignition circuit of your vehicle to be cut off from the inside as an effective anti-theft measure, or to break the electrical circuit of a given device.
Max intensity 100 A, max voltage 24 V.
Dimensions (mm): 90 x 97 x 70.

This 12V to 6V - 3 Ohm voltage reducer is an economical solution for maintaining your 6V electrical accessories.
It's tempting to convert your 6V vehicle to 12V, but many accessories aren't compatible.Supporting accessories up to 50W, this voltage reducer offers a 3 Ohm resistance and simply connects in series to the wiring of the accessory you wish to keep in 6V.
It can be grounded, screwed to the body or wired.
Input voltage 12V > output voltage 6V

6 Volt 84 Ampere battery
Vintage-style model without base
Supplied empty for transport.

This battery must be refilled with a specific acid (not provided) and charged using a suitable device prior to being installed in the vehicle. For safety reasons, Mecatechnic does not ship acid.

Dimensions: 22cm(L) x 17cm(W) x 20cm(H)

Protects the bodywork from acid splashes, prevents paintwork destruction and corrosion of the battery holder. Universal mat to be placed under the battery (cut to size if necessary).
dimensions in mm (L x W x D) : 310 X 204 x 2.5

Indispensable for all motorhomes fitted with an auxiliary battery, it recharges it slowly and automatically while driving, thus avoiding excessive flow from the alternator and the original circuit. Not for connection to lithium batteries.

Model for 1 auxiliary battery.
Max. battery capacity: 300 Ah.
Charging current: 50A nominal, 70A instantaneous (max).
Standby consumption < 50µA.
Motor battery voltage: 12V.
Auxiliary battery voltage: 12V.
Coupling information: yes.
Operating temperature: -20°C/ 50°C.
Cable cross-section: maximum 6mm².
Overall dimensions: 120 x 59 x 35 mm, case: 89 x 60 x 35 mm.
Fixing center distance: 105 mm.
Weight: 250 g

Product benefits:
- Protected main battery and alternator. Extended service life.
- Permanently charged auxiliary batteries.
- Automatic, unattended operation.
- Possibility of recharging the main battery via the charger, solar panel or wind turbine (useful during wintering).

WARNING: Protect each battery outlet (terminal ) with a 50A MAXIFUSE fuse, not supplied.

For low-capacity batteries.
Indispensable for all motorhomes with auxiliary batteries, it recharges them slowly and automatically while you're on the road, avoiding excessive flow from the alternator and the original circuit.
Starts for 3 batteries, including fridge relay. Do not connect to lithium batteries.
Base: grey or black.
Max. battery capacity: 300 Ah.
Charging current: 50A nominal, 70A instantaneous (max).
Cable cross-section: maximum 6mm² .
Overall dimensions: 120 x 59 x 35 mm, case: 89 x 60 x 35 mm.
Weight: 240 g

Product benefits:
- Protected main battery and alternator. Extended battery life.
- Permanently charged auxiliary batteries.
- Automatic, unattended operation.
- Possibility of recharging the main battery via the charger, solar panel or wind generator (practical for wintering).

12V operation without charger or alternator:
On-board applications (pumps, lighting, heating, etc.) are powered by the two batteries in parallel. When the common voltage of these two batteries reaches 12.7V ( or - 0.1V), the main battery disconnects. Consumption for the various applications will then come solely from the auxiliary battery.

The separator-coupler has 3 protected feeders:
- E1 (on auxiliary battery) protected by a 30A fuse.
- an E2 feeder (on motor battery) protected by a 15A fuse.
- an E3 feeder (on motor battery) for the absorption refrigerator, protected by a 15A fuse.

Retaining plate for the battery.

For:
For Beetle & Karmann-Ghia since 08/1967->
- Combi Bay Window, 08/1967 ->07/1970
up to chassis N°->210 2300 000.
- Utility LT, all models 1976 ->1996

Retaining plate for the battery.
To be welded on the floor in front of the battery

For:
For Beetle & Karmann-Ghia since 08/1967->
- Combi Bay Window, 08/1967 ->07/1970
up to chassis N°->210 2300 000.
- Utility LT, all models 1976 ->1996

Battery wedge.
To be welded to the floor in front of the battery

For VW Beetle (08/1955-07/1966)

Protective cover for vintage batteries.
Faithful reproduction in black painted metal.
Dimensions: 220 x 175 x 35 mm

Examples of vehicles:
- VW Beetle, until ->07/1955
- Porsche 356

Protective cover and fixing strap for vintage batteries. Made of metal painted matte black. Wooden inside insulation.
Dimensions: 195 x 180 x 35mm

Examples of vehicles:
- Beetle, 12/1947 ->07/1967
- Porsche 356

Pair of clips for attaching the protective cover on the battery. Includes both hooks and both springs.

For VW Beetle
Years: until ->09/1952

Fastening flange to attach the battery to the protective cover. Attaches with a bolt on one sideand a hook on the other, as with the original.

For VW:
- Beetle,10/1952 ->09/1955
- Split Screen Camper, 03/1955 ->07/1966